How to DIY Your Speaker Interconnection Cable

0 comments / Posted on by Vincent Zhang

How to DIY Your Speaker Interconnection Cable
There are 5 steps to DIY your Speaker Interconnection Cable, for examples as below.
1. Select your need cable and define its cross section and length.If there is a large current from your power amplifier to the speaker, you will select related high cross section of the cable.Here, we make a speaker interconnection cables for a 10W speaker, so its cross section is smaller.
How to DIY your speaker interconnection cable -- cable
 
2. Select the speaker terminals. There are two types terminals or connectors, like as banana and Y fork connector. Here, we select banana connectors. Please select high quality connectors such as gold-plated pure copper connectors, which have low resistance, good electrical conductivity, anti-oxidation to reduce signal loss.
How to DIY your speaker interconnection cable -- banana connectors
3. Cut the PVC protection cover and twisting the bare copper wires
How to DIY your speaker interconnection cable -- cut cable
How to DIY your speaker interconnection cable--twisting copper wires
4. Fix and screw the banana connectors to the cable and tighten them.
How to DIY your speaker interconnection cable --fix banana connector to the cable
How to DIY your speaker interconnection cable--screw the cable
5. Fix and align the plastic housing to the contact
How to DIY your speaker interconnection cable -- align the plastic housing to the contact
Now, an end of the cable is completed. And then, finish the other 3 ends.
Here, please note the ends will be one-to-one correspondence, red to red with same cable, and so on.
How to DIY speaker interconnection cable
Here is a finished speaker interconnection cable.
So easy! Right?

0 comments

Leave a comment

All blog comments are checked prior to publishing